Brother MFC990CW Service Manual page 220

Inljet mfc/dcp
Hide thumbs Also See for MFC990CW:
Table of Contents

Advertisement

Assembling Note: When assembling the media module cover, control panel base, latch
spring, color LCD unit, and panel plate, follow the steps below.
1) Place the control panel base right side up.
2) Fit the three "z" latches of the media module cover into the openings provided in the
control panel base.
3) Set the latch spring on the control panel base with its convex section facing up so that
the hole and cutout provided in the latch spring become fitted over the front and rear
bosses on the control panel base, respectively, as shown on the previous page.
4) A new color LCD unit is covered with a protection sheet. Before setting it, remove the
protection sheet.
5) Route the LCD flat cable and the touch panel harness
opening of the control panel base; route the grounding wire
square opening (viewed from the top). (See the illustration on the previous page.) And
set the LCD unit on the control panel base.
For models with flat core in the control panel base: When routing the LCD flat
cable through the control panel base, be sure to pass the cable through the flat core
mounted in the square hole in the control panel base.
6) Assemble the panel plate and the control panel base, taking care not to apply pressure
to the media module cover.
*2 For models with touch panel
*3 For models with flat core in the control panel base
6-36
*2
through the large square
*2
through the right small
Confidential
*3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents