Brother MFC990CW Service Manual page 197

Inljet mfc/dcp
Hide thumbs Also See for MFC990CW:
Table of Contents

Advertisement

(3) Disconnect the CIS flat cable from the main PCB, pull it to the rear through the flat core,
and then release it from the cable guides. Unlatch the flat core and take it out of the upper
cover.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
(4) Disconnect the CIS motor harness (4-wire) from the main PCB.
CIS motor harness
DCP585CW
CIS motor
harness
Scanner cover
(Scanner unit)
MFC250C and DCP385C/165C/145C
Main PCB
6-13
CIS flat cable
Flat core
Upper cover
Lower cover
Latch
Main PCB
CIS motor
harness
(6_11)
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents