Haier GDE480BW User Manual page 20

1. Turn the gas supply o by moving the shuto valve to the closed position.
Closed Valve
Open Valve
2. Disconnect and discard old exible gas connector. Replace with a new
CSA(AGA) approved exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a " NPT elbow to the gas inlet pipe on the dryer. Then connect a are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
" NPT Elbow
" NPT Flare Adapter
5. Connect the dryer to the gas supply line with a exible gas connector.
Flexible Gas Connector
6. Tighten the exible gas connector using two adjustable wrenches.
7. Turn the gas supply on by moving the shuto valve to the open position. The
valve is open when the handle is parallel to the gas pipe.
18
A
A
B
B
C
A