Step 3: 3G Status Confirmation - Cisco 3G MicroCell User Manual

Step 3: 3G Status Confirmation

1. Make sure the Power
indicator will be solid green
Wait 90 minutes.
complete system configuration and 3G service activation. Do not turn off power or disconnect.
Note: The
2. After 90 minutes, look at your 3G MicroCell front panel status indicators.
*
If the Power or Ethernet status indicators are not solid green, see the Troubleshooting section on page 14 for more
information.
3G Status Indicator Still Flashing after 90 Minutes?
Try these steps in this order:
1. Confirm that at least
2. Power cycle your 3G MicroCell. (Unplug the power adapter from the wall outlet, wait 10 seconds, then plug it back in.)
Wait 30 minutes
3. If power cycling doesn't resolve the problem, see
provide a solution.
4. If your 3G status indicator still fails to go solid green, see the
Customer Support at
12
and Ethernet status indicators are
or flashing green
You have completed your part. Relax and give your 3G MicroCell time to
GPS and 3G status indicators will start
3G Status Confirmation
*
Power
Solid Green
*
Ethernet
Solid Green
A
GPS
Solid Green
A
Computer
Option A: Off
Option B: Solid Green or Flashing Green (during Data Transfer)
3G
Solid Green
90 minutes have passed since first powering up the 3G MicroCell.
for 3G indicator to go solid
1.800.331.0500 for assistance.
solid green*. If you chose Option B, the
during data transfer.
flashing green within 10
green.
Option C on page 11
Troubleshooting section on page
Computer
minutes.
• If the 3G status indicator is
3G activation is complete. You may
advance to Step 4: Final
• If the 3G status indicator is
after 90 minutes, refer to the steps
below for solutions to try.
for an alternative cabling configuration that may
14, or contact AT&T
status
solid green,
Confirmation.
still flashing