14-12 ELECTRICAL SYSTEM
Flywheel Magneto Removal
Remove the magneto cover.
Hold the flywheel steady with the flywheel holder [A], and
remove the flywheel bolt (KX125) or nut (KX250) [B].
Special Tool - Flywheel & Pulley Holder: 57001-1605
Remove the flywheel holder.
Screw the flywheel puller [A] into the flywheel by turning
it counterclockwise (left-hand thread).
Remove the flywheel from the crankshaft by turning in the
puller center bolt and tapping the head of the bolt lightly
with a hammer, while holding the puller body steady.
There is a woodruff key in the crankshaft tapered portion.
Special Tool - Flywheel Puller, M12 × 1.75: 57001-252
Never strike the grab bar or the flywheel itself. Strik-
ing the bar can bend it. If the flywheel is strike, the
magnets may lose their magnetism.
Unscrew the mounting screws [A], and remove the stator
plate [B] and the wiring grommet [C].
Remove the band.
Remove the number plate.
Disconnect the magneto lead connector [A] from the C.D.I