Insignia has detailed information about
troubleshooting problems on its Web site at:
• Make sure that the power cord is
• Check your antenna input, location,
and unclear sound.
• Select the Auto Tuning or Manual
• Make sure that all the cables are
• The antenna signal strength may be
For more information about connections,
see "Connecting an antenna" on page 5.
Normal picture but
• Check volume levels.
• Make sure that the TV sound is not
• Make sure that the your converter
Picture is distorted.
• Make sure that the correct aspect
• Make sure that the video output is
• You can find all the available
• Adjust the antenna.
• Check the antenna's signal strength.
You forgot your
Enter the master password 7777.
The remote control
• Point the remote control at the
does not work
• Operate the remote control within
• Remove any obstacles between the
• Replace dead batteries with new
Design and specifications are subject to change
without prior notice.
DTV standard ATSC
Dimensions (W × H × D)
Approximately 8.5 × 1.8 × 6.4 inches
(215 × 46 × 162 mm)
Approximately 1.65 lbs. (0.75 kg)
41°F to 104°F (5°C to 40°C)
5% to 90%
120V 60 Hz AC
plugged securely into a power outlet.
and signal strength.
Scan functions, if you have not
already done so.
installed correctly and that the
correct source is selected on your TV
(for example, CH 3, CH 4, Video 1, or
low. Check the signal strength and
adjust the antenna location and
box is connected correctly.
ratio is selected.
connected to the TV.
channels by running the Auto Tuning
or EZ Add in the on-screen menu
remote sensor on your converter
23 feet (7 meters) of the remote
remote control and the remote
Converter Box with Analog Pass Through
Antenna input, ATSC, 75 ohms
Antenna out (To TV (RF))
Antenna output, 75 ohms, RF output
channel 3 or 4 (switchable)
1.0 V (p-p), 75 ohms, negative sync,
RCA jack (1)
2.0 Vrms (1 KHz, 0 dB), 600 ohms,
RCA jack (L, R) (1)
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly
approved in the instruction manual. The user could lose the
authority to operate this equipment if an unauthorized
change or modification is made.
FCC Part 15
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
product is operated in a residential installation. This product
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
product does cause harmful interference to radio or
television reception, which can be determined by turning the
product off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and
• Connect the product into an outlet on a circuit different
• from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
• for help.
Do not attempt to modify your converter box in any way
without written authorization from Insignia. Unauthorized
modification could void the user's authority to operate this
Your converter box is intended to receive and decode
signals transmitted according to the ATSC Digital Television
Standard A/53 specification and is intended to be used with
an appropriate antenna and display device that you must
As an Energy Star Partner, Insignia has determined
that this product or product models meet the Energy
Star guidelines for energy efficiency.