The Password Screen - Hitron CGN User Manual

Table 9: The Status > CM Status Screen (continued)
SCDMA Mode
Signal Power (dBmV) This displays the transmitted power of the signal of each
Channel ID
Cable Modem IP Information
IP Address
Subnet Mask
Gateway IP
DHCP Lease Time
3.5

THE PASSWORD SCREEN

Use this screen to change the password with which you log in to the CGN.
NOTE: If you forget your password, you will need to reset the CGN to its factory
defaults.
Click Status > Password. The following screen displays.
41 41
HITRON CGN USER'S GUIDE
This displays the Synchronous Code Division Multiple
Access (SCDMA) mode of each channel on which the
upstream signal is transmitted.
upstream data channel to which the CGN is connected,
in dBmV (decibels above/below 1 millivolt).
This displays the ID number of each channel on which
the upstream signal is transmitted.
This displays the CGN's WAN IP address. This IP
address is automatically assigned to the CGN
This displays the CGN's WAN subnet mask.
This displays the IP address of the device to which the
CGN is connected over the CABLE interface.
This displays the time that elapses before your device's
IP address lease expires, and a new IP address is
assigned to it by the DHCP server.
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
2012 Hitron Technologies
2012 Hitron Technologies