Camshaft Position Sensor Removal
Remove the lower fairings (see Frame chapter).
Lift the left side of the baffle plate and take out the
camshaft position sensor lead connector.
Remove the left under side radiator bolt.
Move the bottom of the radiator toward the front [A], and
disconnect the camshaft position sensor lead connector
Camshaft Position Sensor Bolt [A]
Camshaft Position Sensor [B]
Camshaft Position Sensor Installation
Apply grease or engine oil to the O-ring on the camshaft
Torque - Camshaft Position Sensor Bolt: 12 N·m (1.2 kgf·m,
Camshaft Position Sensor Inspection
Right Lower Fairing (see Frame chapter)
Camshaft Position Sensor Lead Connector (disconnect)
Set the hand tester to the × 10 Ω range and connect it to
Special Tool - Hand Tester: 57001-1394
If there is more resistance than the specified value, the
sensor coil has an open lead and must be replaced. Much
less than this resistance means the sensor coil is shorted,
and must be replaced.
Camshaft Position Sensor Resistance: 490 ∼ 590 Ω
Using the highest resistance range of the tester, mea-
sure the resistance between the camshaft position sensor
leads and chassis ground.
Any tester reading less than infinity (∞) indicates a short,
necessitating replacement of the camshaft position sen-
ELECTRICAL SYSTEM 16-43