10-16 WHEELS / TIRES
Hub Bearing Removal
Remove the wheel, and take out the following.
Coupling (out of rear hub)
Circlips [A] (Rear Hub only)
Special Tool - Inside Circlip Pliers: 57001–143 [B]
Use the bearing remover to remove the hub bearing [A].
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.
Special Tools - Bearing Remover Shaft, 13: 57001–1377
Bearing Remover Head, 25 × 28:
Hub Bearing Installation
Before installing the wheel bearings, blow any dirt or for-
eign particles out of the hub with compressed air to pre-
vent contamination of the bearings.
Replace the bearings with new ones.
Install the bearings so that the marked side faces out.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
Press in each right the bearing [A] until they are bottomed.
Special Tool - Bearing Driver Set: 57001–1129 [B]
Replace the circlips with new ones (rear hub only).
Special Tool - Inside Circlip Pliers: 57001–143
Replace the grease seals with new ones.
Press in the grease seals [A] so that the seal surface is
flush [B] with the end of the hole.
Apply high temperature grease to the grease seal lips.
Special Tool - Bearing Driver Set: 57001–1129 [C]