9-10 CRANKSHAFT / TRANSMISSION
Apply silicone sealant to the breather plate mating surface
[A] 1 to 1.5 mm (0.04 to 0.06 in.) thick, and wait until
Sealant - Three Bond #1207B and/or equivalent
Install the breather plate [B], and apply a non-permanent
locking agent to the threads and tighten the bolts [A].
Torque - Breather Plate Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the oil jet nozzles [A].
Apply a non-permanent locking agent to the threads of oil
jet nozzle bolts.
Torque - Oil Jet Nozzle Bolts: 6.9 N·m (0.70 kgf·m, 61 in·lb)
Crankshaft and Connecting Rods
Camshaft Chain [A]
Transmission Shaft and Gears
Dowel Pins [B]
Shift Forks and Shift Rods
Before fitting the lower case on the upper case, check the
Be sure to hang the camshaft chain on the crankshaft.
Check to see that the shift drum and transmission gears
are in the neutral position.