8-6 ENGINE REMOVAL/INSTALLATION
Pull off the connectors from the engine and free the wiring
from the clamps.
Pickup Coil Lead Connector [A]
Battery Ground Lead [B]
Starter Motor Lead [C]
Alternator Lead Connector [D]
Side Stand Switch Lead Connector [E]
Speed Sensor Connector [F]
Regulator/Rectifier Lead Connector [G]
Stick Coil Harness Connector [A]
Support the rear part of the frame on the jack.
Special Tool - Jack: 57001-1238
Water Hoses [A]
Support the engine with a suitable stand [A].
Remove the engine mounting bolts and nuts [B].
Loosen the locknuts and adjusting bolts [C].
Special Tool - Engine Mount Nut Wrench: 57001–1450
Remove the drive chain from the output shaft.
Using the stand, take out the engine.