Install the friction plates and steel plates, starting with a
friction plate and alternating them.
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.
Install the last friction plate [A] fitting the tangs in the
grooves in the housing as shown.
Apply molybdenum disulfide grease to the pusher end
[A] and install the bearing [B], pusher [C] spring [D] and
washer [E] in the clutch spring plate [F].
Apply molybdenum disulfide grease to the pusher end [A]
and install the shim [B], bearing [C], pusher [D] and spring
[E] in the clutch spring plate [F].
Install the clutch spring plate, spring and spring holders,
and tighten the clutch spring bolts.
Torque - Clutch Spring Bolts: 8.8 N·m (0.90 kgf·m, 78 in·lb)
Install the clutch cover (see Clutch Cover Installation).