Connect the fuel pump lead connector [A].
Insert the fuel hose joint [B] straight onto the delivery pipe
until the hose joint clicks.
Push and pull [C] the hose joint [B] back and forth, and
make sure it is locked and does not come off. When the
hose joint is correctly installed, it should slide on the de-
livery pipe about 5 mm (0.2 in.).
If it does not slide, reinstall the hose joint.
Make sure the hose joint is installed correctly on the
delivery pipe by sliding the joint, or the fuel could
Fuel Tank Inspection
Remove the hose(s) from the fuel tank, and open the tank
Check to see if the water drain pipe [B] and fuel breather
pipe [C] in the tank are not clogged. Check the tank cap
If they are clogged, remove the tank and drain it, and then
blow the breather free with compressed air.
Do not apply compressed air to the air vent holes
[A] in the tank cap. This could cause damage and
clogging of the labyrinth in the cap.
Fuel Tank Cleaning
Clean the tank in a well-ventilated area, and take
care that there are no sparks or flame anywhere
near the working area. Because of the danger or
highly flammable liquids, do not use gasoline or low
flash point solvents to clean the tank.
Remove the fuel tank (see Fuel Tank Removal).
Drain the fuel.
Remove the fuel pump assy.
Pour some high flash-point solvent into the fuel tank and
shake the tank to remove dirt and fuel deposits.
Pour the solvent over of the tank.
Dry the tank with compressed air.
Install the fuel pump assy (see Fuel Pump Installation).
Install the fuel tank (see Fuel Tank Installation).
FUEL SYSTEM (DFI) 3-109