Download Print this page

Brand Search; Code Identification Feature - Black & Decker freewire Instruction Manual

Master remote control
Hide thumbs

Advertisement

622715-00 Master Remote manual
CODE ENTRY , cont.
CODE SEARCH BY BRAND
Lets you search for a code for a specific
Brand within the Code Library for a
particular manufacturer.
1. Turn on the device (TV, VCR, etc.) to
be controlled.
2. Press and quickly release the desired
mode button (TV, VCR, etc.).
3. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button.
4. Press and release the numeric button
(0-9) corresponding to desired
Manufacturer (see table on separate
sheet). The green indicator blinks off
once.
NOTE: Pressing "0" performs a full
library search same as normal Code
Search Method on previous page.
5. Press the CHANNEL UP button ((or
POWER or PLAY (VCR only))
repeatedly until the device to be
controlled changes channel. The green
indicator blinks off with each button
press. If you accidentally overshoot the
code required, press the CHANNEL
DOWN button to backtrack through the
library until the device changes
channel. Pressing CHANNEL UP
changes direction to forward again.
6. Press and release MUTE to install the
code.
Brand Search Method entry is now
complete.
Note: When all codes under a Brand
have been searched the red indicator
flashes rapidly for 3 seconds.
2.
3.
4.
6.
5.
2/4/04
9:17 AM
Page 11
BRAND SEARCH TABLE
Look up your brand in the appropriate
column (TV, VCR, etc.). Look to see
what digit (1, 2, 3, etc.) applies to your
brand, and enter it in step 4 of "Code
Search by Brand" on separate sheet.

CODE IDENTIFICATION FEATURE

The Code Identification Feature allows
you to identify the three digit library code
stored under your device key.
For example, if you want to find out what
three digit code is stored under your TV
device key, follow the six steps below:
1. Press and quickly release the desired
mode button (TV, VCR, etc.).
2. Press and hold the SETUP button until
the Mode button stays on. You can
now release the SETUP button.
3. Press and release the SETUP button.
The green indicator blinks off.
4. To find the first digit for the code stored
under the mode key pressed in step 2,
press each numeric key from 0-9 in
turn. When the green indicator blinks
off the number you pressed is the first
digit for the code you are searching for.
5. To find the second digit, repeat step 4,
this time when the green indicator
blinks off this is the second digit.
6. Repeat step 4 again to find the third
digit.
1.
2,3.
4,5,6.
11

Advertisement

loading

  Also See for Black & Decker freewire

  Related Manuals for Black & Decker freewire

  Related Content for Black & Decker freewire

This manual is also suitable for:

Freewire fwmr