Maintenance - Uwatec Aladin Air z Operating Manual

1 Maintenance of Aladin
Your Aladin ® Air Z is virtually maintenance free. All you need to do is to rinse it carefully with fresh water
after each use and to have the batteries changed when needed. To avoid possible problems with your
Aladin Air Z, the following recommendations will help assure that it will give you years of trouble free
®
service:
80
® Air Z Dive Computer
• Avoid dropping or jarring your Aladin
• Do not allow your Aladin
• Rinse your Aladin Air Z thoroughly with fresh water after each dive.
®
• Do not store your Aladin
is free ventilation.
• If there are problems with operating the contacts, the surface of your Aladin
Air Z housing can be treated with silicone grease. Use soapy water to clean the
Aladin Air Z before using silicone grease and dry it thoroughly.
®
• Never pressure the Aladin
• There are borings in two of the contacts for the reception of the PC interface
connection (MemoMouse). Free these borings from dirt with a needle if neces-
sary.
Take the dive computer or the transmitter to an authorized Uwatec dealer in
order to change the batteries. The actual change of the batteries is made at
the manufacturer or the importer. The computer is checked for its technical
functioning at the same time. Do not attempt to have the batteries changed
by anyone other than an authorized dealer.
® Air Z.
Air Z to be exposed to direct, intense sunlight.
®
Air Z in an gas mixture-tight area; make sure there
®
® Air Z out of water.
®
IX Uwatec Aladin Air Z
® ®