Set Up The Receiver - Amplicomms TV 2400 User Manual

G G
ERÄTE IN ETTING STARTED

Set up the receiver

Installing and charging the battery
1 Insert a battery into the headset receiver with correct polarity.
2 Charge the battery for about 2 hours and 30 minutes
before first use. Switch off the receiver (position OFF).
Place the receiver into the charging cradle of the trans-
mitter. The charging process starts automatically. The
battery LED indicator will be red and will turn to green
when the battery is fully charged. This takes about 2
hours and 30 minutes.
3 Insert the spare battery into the
base as indicated in the drawing.
The LED will remain red and turn
green when it is fully charged after
about 2 hours and 30 minutes.
• A fully charged battery provides up to 5 hours of listening enjoy-
ment.
• To conserve battery power, the receiver automatically shuts off if no
signal is detected for a period of approx. 5 minutes or when the level
is too low. However, if the signal returns to an acceptable level, the
transmitter will automatically switch ON again.
4
B
ETRIEB NEHMEN
Helpline UK 0844 800 6503
(See page 32 for costs and hours of operation)