Discovery Device - powersoft M50Q HDSP+ETH User Manual

M Series User Guide
assigns a link-local address of the type 169.254.x.y with a subnet
mask 255.255.0.0. Please make sure that your PC is in the same
subnet of the unit. Modern operating systems provide Zeroconf
features for network auto-configuration.
6.2.1.3 Static IP
M Series devices can be set up with a static IP (or any other IP
policy) with the Armonía control software. In order to set up the
IP address please follow these steps:
1. Connect the device in a network with or without DHCP (see
the previous paragraph).
2. Discover the device and import it in the workspace (refer to
the Armonía user guide).
3. Go to the device scheme tab and select the Network settings
button.
FIGURE 18: Enter the network settings.
4. Select the Static addressing mode from the combo box
FIGURE 19: Select the static IP policy.
5. Insert the desired IP Address and network mask. Specifying
the gateway is necessary only in complex LANs.
FIGURE 20: Insert IP, subnet, and net mask in the form.
6. Click apply settings button.
WARNING: the device is reachable only from PCs in the same
subnet mask, if this information is lost you will need to re-init the
network device with a third-party software. Refer to 11.1 on page
27.
When done, the device network will restart automatically. The
device will reconnect in approximately 15 seconds.
16
▶
6.2.1.4 Revert From Static IP
If for any reason re-programming the IP address or the IP policy
of your unit should be necessary, follow the instructions in the
previous chapter and make a different selection when assigning
the IP. For example, should you need to revert the device to the
automatic (DHCP, Zeroconf) IP settings, please follow these steps:
7. Connect the device in a network with or without DHCP (see
6.2.1.3 on page 16)
8. Discover the device and import in the workspace (refer to
the Armonía user guide). Device and PC must use the same
subnet. If you are not able to reconnect the device please
refer to section 11.1 on page 27
9. Go to the device scheme tab and select the Network settings
button
FIGURE 21: Enter the network settings
10. Select the Static addressing mode from the combo box
FIGURE 22: Select the auto IP policy
11. Click apply settings button.
12. When done, the device network will restart automatically.
The device will reconnect in approximately 15 seconds.
6.2.2

Discovery Device

In order to start remote operation on the device connected
to your network, it must be discovered and imported into the
Armonía workspace.
FIGURE 23: In order to discover device press the discovery button.