Creating Your Own Startup Screen - Epson PowerLite 1810p User Manual

Starting the Projector with a Password
When the password function is enabled, you see this screen when you
plug in and turn on the projector:
Hold down the button on the remote control and use the
Num
numeric keypad to enter the four digit password. The password screen
closes and projection begins.
If the password is not correct, you see a message prompting you to
re-enter the password. If you enter an incorrect password three times
in succession, you see the message
and the projector switches to standby mode. Disconnect the
locked
projector's power cord from the electrical outlet, reconnect it, and
turn the projector back on.
When you see the Password screen again, you can try to enter the
correct password.
If you enter an incorrect password 30 times in succession, the
projector remains locked and you must contact Epson to unlock it.
If you have forgotten the password, contact Epson with the request
code number that appears in the Password screen for assistance. See
"Where To Get Help" on page 83.

Creating Your Own Startup Screen

You can transfer any image from your computer or video source to the
projector and then use it as your startup screen. You can also use it as
the screen displayed when the projector is not receiving a signal or
when you press the
A/V Mute
logo, slogan, photograph, or any other image you want to use.
The projector's operation will be
button. The image can be a company
note
If you leave the projector
plugged in, the Password
Protect Release screen will
not appear. It appears only
if you unplug and reconnect
the power cable.
Hold down
Fine-Tuning the Projector
57