Amped Wireless REA20 User Manual page 64

REA20
b. The connection to your Home Network may have been dropped or the router settings may have
changed. Changes to the router could be a result of several events, such as a power outage. When this
occurs, connect to the Range Extender and access the setup menu using the web address:
http://setup.ampedwireless.com. Run the Setup Wizard to reconnect the Range Extender to your
network.
c. The Range Extender may be too far from your home router and not maintaining a signal strength of
above 70%. Check the signal strength between the router and the Range Extender through the web
menu (left side): More Settings > Management > Device Status. The Signal Strength readout will be
under the Home Wireless Network Settings section. This Signal Strength must be above 70%. If it is
below, move the Range Extender closer to your router, or reposition the Range Extender.
d. Check that your antennas are connected to their corresponding antenna connectors. The number
designated on the antenna (1-3) should match the number on the antenna connector (1-3).
e. Rescan for another network by accessing http://setup.ampedwireless.comto connect to and repeat or
you may try to fix the issues with your Home Network and your home wireless router.
f. Check to see that your home wireless router settings have not changed. Any changes to the SSID,
security, or channel number from the original settings will disconnect the Range Extender's connection
to the home network To solve this simply run the Setup Wizard again from the web menu and
reconfigure your Home Network connection. You can also set a static channel number on your router
to prevent this from happening again in the future.
USER'S GUIDE
63