Chapter 4
Feature Setup
Table 4-6
Option
Duration
Event Notification Window
The Event Notification window provides options for how the IP camera handles events. An event is any
of the following:
•
•
•
When an event occurs, it triggers the IP camera to take certain configured actions:
•
•
•
OL-28694-01
IO Ports Window Options (continued)
Description
If you checked the Automatic Reset check box, enter the amount of time, in
milliseconds, that elapses before the port goes back to its default state after
an event changes it from the default state.
A change of state from low to high or from high to low on an input port of the IP camera. For related
information about input ports, see the
Motion that the IP camera detects. For related information about motion detection, see the
detection controls"
rows in
Loss of video signal.
HTTP notification—IP camera sends notification to a remote system via HTTP. This information
includes the following:
Device ID—ID of the IP camera
–
Device name—Name of the IP camera
–
–
IP address—IP address of the IP camera
–
MAC address—MAC address of the IP camera
–
Channel ID—Channel identification number (1 for primary stream or 2 for secondary stream)
Channel name—Name that is configured for the channel
–
Date and time—Date and time that the event occurred
–
Active post Count—Sequence number of the notification for this event
–
Event type—Type of event
–
Event state—Indicates whether the event is active or inactive at the time that the event was
–
detected for this notification
Event description—Description of the event.
–
Input port ID—If the event was triggered by an input port state change, port ID of the port
–
Region index—If the event was triggered by motion detection, identification number of the
–
region in which the IP camera detected motion
Sensitivity level—If the event was triggered by motion detection, sensitivity that is configured
–
for the region in which motion was detected
Detection threshold—If the event was triggered by motion detection, threshold that is
–
configured for the region in which motion was detected
Output port state change—Changes the state of an IP camera output port from low to high or from
high to low.
Syslog server message—Sends a notification message to the designated Syslog server.
Cisco Video Surveillance 7000 Series IP Camera Configuration Guide, Release 1.1.4
"IO Ports Window" section on page
Table
3-1.
Event Notification Window
4-10.
"Motion
4-11