Cisco 7000 Series Configuration Manual page 24

Streaming Window
To display the Streaming window, perform the following steps:
Procedure
Step 1 From the IP camera user interface, click the Setup link.
Click Feature Setup to expand the menu.
Step 2
From the Feature Setup menu, click Streaming.
Step 3
The Streaming window appears. If you change any options in this window, you must click the Save
Settings button to save the changes. If you do not click this button, changes are not retained when you
exit the window. Save Settings appears at the bottom of the window. You may need to scroll down to it.
Table 4-3
Table 4-3
Option
Current Stream Area
Stream
Enable Stream
Streaming Area
Note
Enable SRTP
RTSP Port
Video Source Port
Cisco Video Surveillance 7000 Series IP Camera Configuration Guide, Release 1.1.4
4-4
describes the options in the Streaming window.
Streaming Window Options
Description
Choose the video stream (Stream 1 or Stream 2) to which the configuration
settings in the Streaming window apply. Stream 1 is the primary stream, and
Stream 2 is the secondary stream.
Check this check box to cause the IP camera to send video data on the
selected stream.
Stream 2 can be enabled only if Stream 1 is set to a video resolution
Note
lower than 1920 x 1080.
Each video stream uses its own set of streaming options. The settings shown in the Streaming
Area apply to the currently selected stream only.
Check this check box to enable Secure Real-time Transport Protocol (SRTP),
which provides encryption for the video stream from the IP camera.
SRTP is not supported in this release and is disabled in the UI.
Note
Transmission Control Protocol (TCP) port on which the IP camera receives
Real-Time Streaming Protocol (RTSP) commands. You must configure this
port if you want to allow third-party devices or software to access video
streams from the IP camera.
RTSP is a standard for connecting a client to control streaming data over the
web.
Valid values are 554 and 1024 through 65535. The default port is 554.
Universal Datagram Protocol (UDP) port on which the IP camera transmits
Video Real-Time Transport Protocol (RTP) data.
Valid values are even numbers 1024 through 65534. The default port is 1024.
Chapter 4 Feature Setup
OL-28694-01