HP 377707-002 User Manual page 63

Table 5-9: Topology Port Properties Window Fields (Continued)
Field
In Part Enforce
Out Part Enforce
In Filter Raw Packet Enforce Boolean value that indicates whether or not to support optional
Out Filter Raw Packet
Enforce
MKey Violation
PKey Violation
QKey Violation
GUID Cap
Subnet Timeout
Response Time
Local Physical Error
Description
Boolean value that indicates whether or not to support optional
partition enforcement for the packets received by this port.
There is no default value.
Boolean value that indicates whether or not to support optional
partition enforcement for the packets transmitted by this port.
There is no default value.
raw packet enforcement for the raw packets received by this
port. There is no default value.
Boolean value that indicates whether or not to support optional
raw packet enforcement for the raw packets transmitted by this
port. There is no default value.
Number of subnet management packets (SMPs) that have been
received on this port with invalid M_Keys since initial powerup
or the last reset. Refer to section 14.2.4, Management Key,
"InfiniBand® Architecture, Vol. 1, Release 1.0", for more
information.
Number of SMPs that have been received on this port with
invalid P_Keys since initial powerup or the last reset. Refer to
section 9.2.7, partition key (P_KEY), "InfiniBand®
Architecture, Vol. 1, Release 1.0", for more information.
Number of SMPs that have been received on this port with
invalid Q_Keys since initial powerup or the last reset. Refer to
section 10.2.4, Q Keys, "InfiniBand® Architecture, Vol. 1,
Release 1.0", for more information.
Number of GUID entries allowed for this port in the port table.
Any entries that exceed this value are ignored on write and read
back as zero. Refer to section 14.2.5.5, GUIDCap,
"InfiniBand® Architecture, Vol. 1, Release 1.0", for more
information.
Maximum propagation delay allowed for this port to reach any
other port in the subnet. This value also affects the maximum
rate at which traps can be sent from this port. Delay is affected
by switch configuration. This parameter, along with resp-time,
may be used by requestors to determine the interval to wait for a
response to a request before taking other action. Duration is
calculated as (4.096 ms * 2^SubnetTimeout).
Maximum time allowed between the port reception of a subnet
management packet and the transmission of the associated
response. Refer to section 13.4.6.2, Timers and Timeouts,
"InfiniBand® Architecture, Vol. 1, Release 1.0", for more
information.
Threshold at which ICRC, VCRC, FCCRC, and all physical
errors result in an entry into the BAD PACKET or BAD
PACKET DISCARD states of the local packet receiver. Refer to
section 7.12.2, Error Recovery Procedures, "InfiniBand®
Architecture, Vol. 1, Release 1.0", for more information.
55