Disassembly Instructions - Mitsubishi Electric MXZ-2C30VA Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MXZ-2C30VA MXZ-2C40VA MXZ-2C52VA
OPERATING PROCEDURE
1. Removing the cabinet
(1) Remove the screw fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor connecting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
Photo 2
Screw of the
cabinet
Screws of
the cabinet
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Screws of
the relay panel and
the back panel
Screw of the
service panel
Direction to
remove
Hooks
103
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF power supply before disassembly.
PHOTOS
Photo 1
Screws
Screw of
of the
the cabinet
top panel
Screws of
the cabinet
Screws of
the top panel
Back
panel
Screw
of the
back
panel
Service
panel