Li-Ion Battery Charge - SanDisk Sansa e200 User Manual

Li-ion Battery Charge

The Sansa e200 comes with a replaceable Li-ion rechargeable battery. To
use the device for the very first time, remember to fully charge the Li-ion
battery. You can charge your Sansa through the USB port of your computer,
a car adapter (not included) USB port, or AC adapter (not included) USB
port.
Computer USB charging instructions below:
1. Connect the small connector of the USB Cable to the USB port on the
computer, and then plug the larger end in to the Sansa e200 Dock
Connector. The computer must be on for most USB ports to charge your
battery. Your Sansa will show connected and the yellow charging indica-
tor will appear. The battery level indicator will blink while charging.
You will not be able to play while connected to the computer USB.
2. To stop recharging, disconnect the cable.
If you are using an AC adapter(not included) or Car Adapter(not included),
you will be able to play your device while charging.
The Li-ion rechargeable battery will reach approximately 70% charge in 2.5
hours and full charge in about 3.5 hours. It is recommended that you fully
charge your Sansa e200 before first use.
Note: Some low-power USB ports may not be able to provide enough charge
power. Also note that rechargeable batteries may eventually need to be re-
placed as they have limited charge cycles (which vary with use and settings).
9