Configuration Information - Factory Integrated Models - HP PROLIANT DL180 Quickspecs
Hp server user manual
Hide thumbs
Also See for PROLIANT DL180:
- Maintenance and service manual (98 pages) ,
- Quickspecs (57 pages) ,
- Integration notes (26 pages)
Advertisement
QuickSpecs
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid
configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on CTO product offerings and requirements.
NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a CTO Chassis.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Configuration (choose one of the following configurable models)
Hot Plug LFF Models
HP ProLiant DL180 G6 Hot Plug SAS/SATA Rack CTO Chassis
Factory Integrated Model ships with:
HP NC362i Integrated Dual Port Gigabit Server Adapter
Three available PCI-Express slots:
Slot 1: x16 low-profile/half-height slot
Optional Slots 2, 3, & 4: 2x8 full-height/full length, 1x4 full-height/full length
(Recommended)
NOTE: Optional PCI-X option kit includes: Slot 1 and 2: full-length/full-height
PCI-X 100. PCI-X slots are 64 bits; 133 MHz capable if only one PCI-X card is
installed in the server.
NOTE: Optional FL/FH option kit includes: Slot 1: full length/full height slot.
One HP SATA Embedded Cable Kit
One Highline IEC Power Cord
4 Non-Hot Plug Fans
Rack (2U), (3.5 in/8.89 cm)
Tool-less Fixed Rails
Hot Plug SFF Models
HP ProLiant DL180 G6 Hot Plug SAS/SATA Rack CTO Chassis
Factory Integrated Model ships with:
HP NC362i Integrated Dual Port Gigabit Server Adapter
Three available PCI-Express slots:
Slot 1: x16 low-profile/half-height slot
Optional Slots 2, 3, & 4: 2x8 full-height/full length, 1x4 full-height/full length
(Recommended)
NOTE: Optional PCI-X option kit includes: Slot 1 and 2: full-length/full-height
PCI-X 100. PCI-X slots are 64 bits; 133 MHz capable if only one PCI-X card is
installed in the server.
NOTE: Optional FL/FH option kit includes: Slot 1: full length/full height slot.
One HP SATA Embedded Cable Kit
One Highline IEC Power Cord
4 Non-Hot Plug Fans
Rack (2U), (3.5 in/8.89 cm)
DA - 13248 Worldwide QuickSpecs — Version 22 — 7/13/2010
HP ProLiant DL180 Generation 6
507168-B21
594911-B21
Page 20
Advertisement
