Preparing The Rack; Hp Netserver Rack Mount Parts List; Marking The Rack And Attaching Rack Nuts - HP NetServer LC 2000r Installation Manual

Chapter 8

Preparing the Rack

The column adapters and rack nuts must be connected to the rack before mounting
the slide mechanism. Once the slides are correctly mounted, then the HP
NetServer LC 2000r can be installing into the rack. A cardboard rack mounting
template comes with the HP NetServer. The template identifies the column
adapter and rack nut locations on the rack.

HP NetServer Rack Mount Parts List

Ensure the rack-mounting kit provided with the HP NetServer contains the
following parts:
Table 8-1. Parts for Rack Mount Kit
Quantity
2 Slides
4 Rack Nuts
12 Rack Nut Screws (M5 x 16mm)
6 Screws for Slides (8-32 x ¼ inch, 4 panhead and 2 flathead)
2 Column Adapters
1 Template

Marking the Rack and Attaching Rack Nuts

Use this section to mark the front columns and attach the rack nuts to the rear
columns of the HP System/E or HP System/U rack. The column adapters attach to
the front columns and the slides are attached to the column adapters and the rack
nuts to hold the NetServer's slides in place. The rack template and marking pen
are used to identify and mark the locations on the columns.
CAUTION
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.
NOTE
Use the HP Rack Configuration Tools to determine where in
the rack to mount the HP NetServer. The tools are available at:
http: //www.hp.com/netserver/support
82
Rack-Mounting the HP NetServer
Description