HP NetServer LC 2000r Installation Manual page 39

Chapter 3
12. To replace the left side cover, position the cover's tabs next to the
respective holes along the outer edge on the side of the chassis.
13. Slide the cover toward the rear.
14. Tighten the thumbscrew at the front of the cover.
15. To replace the right side cover, position the cover's tabs next to the
respective holes along the outer edge on each side of the chassis.
16. Slide the cover toward the rear.
17. Tighten the thumbscrew at the front of the chassis.
18. To replace the bezel, insert the tabs at the bottom of the bezel into the slots
on the chassis.
19. Swing the top of the bezel toward the chassis until it snaps into place. See
Figure 3-8.
20. Return the HP NetServer to normal operation.
Opening and Closing the HP NetServer
Figure 3-8. Replacing the Bezel
31