HP NetServer LC 2000r Installation Manual page 151

Chapter 12
1 2 3 4 5
4. Insert the new battery with the positive sign (+) facing out, and ensure it is
seated completely.
5. Verify the retaining clip is in place, and holds the battery firmly.
6. Replace the left side cover (or top cover) and the front bezel, and reconnect
the power cord.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
7. Restore power to the HP NetServer according to the respective NOS's
power up instructions.
8. Reset the Date and Time in the Setup Utility.
Refer to Chapter 10, "Configuring the HP NetServer."
6
Configuration Switch
Battery
Figure 12-2. Battery on System Board
Troubleshooting
143