HP NetServer LC 2000r Installation Manual page 15

Chapter 1
13. Connect the monitor, keyboard, and mouse to the rear of the HP NetServer.
Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and UPS."
14. Connect all other external cables to the rear of the HP NetServer.
15. Obtain the release history of the HP NetServer Navigator CD-ROM
provided with the HP NetServer, to ensure you have the latest Navigator
CD-ROM.
Refer to Chapter 10, "Configuring the HP NetServer."
16. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
17. Insert the Navigator CD-ROM and reboot the HP NetServer.
18. Check the Navigator README file for important installation information.
Refer to Chapter 10, "Configuring the HP NetServer."
19. Configure the HP NetServer with Configuration Assistant from the
Navigator CD-ROM, using the Express Configuration option.
Refer to Chapter 10, "Configuring the HP NetServer."
NOTE
To fully configure the HP NetServer, all the rack components
should be cabled and online (though not necessarily installed in
the rack.) Use the HP NetServer LC 2000r Rack Cabling
Reference Guide for more details.
20. Verify the HP NetServer's operation and troubleshoot as necessary.
Your HP NetServer installation should be complete. If not, refer to
Chapter 12, "Troubleshooting."
21. If you plan to ship the fully-configured HP NetServer LC 2000r to a
different destination:
a. Label each cable and component to facilitate re-assembly.
b. Remove all components from the rack, including external mass storage.
c. Repack the components in the original packing material, and prepare
each one for shipment.
CAUTION
It is critical to disassemble and rebox all electronic
components before reshipment. Electronic components
(especially hard disk drives) can sustain damage when shipped
in rack enclosures.
Setting Up the HP NetServer
7