Clearing The System Configuration - HP NetServer LC 2000r Installation Manual

Chapter 12
Verify all DIMMs are HP-supplied and are seated properly. The boot
screen provides information on the installed DIMMs.
Verify all internal cabling and connections.
If you have changed any switches on the system board, verify the
switches are properly set.
5. Replace the cover and front bezel, and connect all cables.
6. Turn on the display and HP NetServer.
7. If the HP NetServer still does not work:
Repeat steps 1, 2, and 3 of this section.
Remove all accessories, except the primary boot hard disk drive.
Replace the covers and connect all cables.
Turn on the display and the HP NetServer.
If the HP NetServer now works, replace the boards and accessories one
at a time to determine which one is causing the problem.

Clearing the System Configuration

You may need to clear the system configuration if the configuration has been
corrupted, or if incorrect settings made in the Setup Utility have made the display
unreadable.
Shaded rectangle
represents the
position of slide
switch.
Open = Off Closed = On
2
3
4
5
6
8
Rear of HP NetServer
Figure 12-1. System Switch Positions
Troubleshooting
Processor Speed (Bit 1)
Processor Speed (Bit 2)
Processor Speed (Bit 3)
Clear Configuration
Clear Password
FSB Speed (133/100 MHz)
137