HP BladeSystem c-Class Troubleshooting Manual page 52

Step
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Procedures: HP BladeSystem c3000 Enclosure DVD-ROM troubleshooting
CAUTION:
avoid possible data loss, always secure permission before powering down an enclosure.
DVD-ROM drive troubleshooting action and verification
Action
Press the eject button on the DVD-ROM drive.
Verification
If the DVD-ROM drive ejects, then the repair is complete.
If the DVD-ROM drive does not eject, then proceed to step 2 of "Procedures: HP
BladeSystem c3000 Enclosure DVD-ROM troubleshooting (on page 52)."
Action
Connect to the DVD-ROM drive:
1 Use the Insight Display to navigate to the Enclosure Settings screen.
2 Select DVD Drive 'Connect...'
3 Press the OK button.
Verification
If Insight Display reports "DVD Connect Status," then continue to step 7.
If the Insight Display does not report DVD Connect Status, then continue to the next step.
Action
1 On the Change USB/DVD Options screen, use the Insight Display up arrow key to
highlight No Change.
2 Press the OK button twice.
Verification
Be sure that the Insight Display changes to the DVD Connect Status screen. Continue to the
next step.
Action
1 On the Insight Display, highlight all bays.
2 Select Change.
3 Press the OK button.
Verification
Be sure that the Insight Display changes to the Connect: Enclosure DVD screen. Continue
to the next step.
Action
1 Using the Insight Display up arrow key, select All Blades = Disconnect.
2 Press the OK button twice to accept changes.
Verification
Be sure that the Insight Display changes to Confirm: DVD Operation. Continue to the next
step.
Action
To confirm disconnecting the DVD-ROM drive, select OK on the Insight Display, and then
press the OK button.
Verification
The Insight Display displays a locked symbol for a short time while disconnecting all server
blades from the DVD-ROM drive.
Verify that all DVD-ROM status icons are gray, indicating that the server blade is not
connected to the DVD-ROM drive. Return to step 4.
Some troubleshooting procedures require powering down an entire enclosure. To
Enclosure troubleshooting 52