Assembly; Fitting The Cutting Head; Checking The Drive Shaft And Flanges; Blade Guard - Husqvarna K1250 ACTIVE Operator's Manual

Fitting the cutting head

Remove the bolts (1). Remove
the cover. Fit the drive belt
over the clutch drum. Refit the
cover and tighten the bolts.
Feed the drive belt over the
pulley on the cutting head (2).
Slide on the belt cover and
secure the cutting head
together with the belt guard.
Tighten both bolts (4) by hand.
Screw in the tensioning screw
(3) so that the square nut is in
line with the arrow on the belt
guard. Shake the head to
ensure the spring can tension
the belt. This automatically
adjusts the belt to the correct
tension. Tighten both bolts (4)
using the combination
spanner.
NOTE! After fitting a new belt
the belt tension must be
readjusted after the first two
tanks of fuel have been used.

Checking the drive shaft and flanges

• Check that the threads on
the drive shaft are
undamaged.
• Check that the contact
surfaces of the cutting blade
and flanges are flat, run
correctly on the spindle and
are free from foreign
objects.
Do not use flanges that are
twisted, have damaged
edges, untrue or dirty. Do
not use different size
flanges.

ASSEMBLY

1
2
4
3

Fitting the cutting blade

Partner cutting blades are
manufactured and approved
for freehand cutting. The
paper labels on each side of
the blade are there to
distribute the pressure from
the flange washer and prevent
the blade from slipping.
The blade is placed between
the flange hub (A) and the
flange washer (B). The flange
washer is turned so that it fits
in the flange hub. The cutting
blade is tightened using the
socket spanner 501 69 17-02.
The shaft can be locked using
a screwdriver, steel pin or the
like. This is slid in as far as
possible. The blade is tighte-
ned clockwise.
Tightening torque for the bolt
holding the blade is:
15-25 Nm (130-215 in.lb).

Blade guard

The blade guard should
always be fitted on the
power cutter.
The guard should be adjusted
so that the rear section is
close to the work piece.
Cutting fragments and sparks
are then collected by the
guard and led away from the
user.
!
WARNING!
16 inch blade and blade guard should only be
used on power cutters originally equipped
with a 16" blade guard. If a blade guard is
fitted as a spare part on a power cutter
originally equipped with a 14" blade guard, the
16" cutting blade will rotate too fast. A cutting
blade with too high speed can burst or cause
serious injury and damage.
A
B
13
English –