tap assembly - tap lever
to use your smoothie
1 Fit the sealing ring over the blade
2 SB260 series
Screw the blade assembly onto the
To fit the blade assembly to the
goblet, line up the
the blade assembly with the
symbol on the goblet. Then turn to
symbol to lock into place.
3 Screw the tap assembly onto the
goblet. Check that the dispensing
tap lever is in the off position
4 Place the assembled goblet on the
5 Place the liquid ingredients into the
This includes fruit (not frozen), fresh
yoghurt, milk and fruit juices. These
can be placed into the goblet to the
level marked LIQUIDS for either 2 or
6 Add ice or frozen ingredients to the
This includes frozen fruit, frozen
yoghurt, ice cream or ice. These can
be added up to the level marked
FROZEN INGREDIENTS for the
corresponding number of servings.
- tap body
7 SB260 series
Screw the lid onto the goblet.
Push the lid onto the goblet.
8 Either push the cap into the lid or
place the stirrer in the hole.
The stirrer can be used when
blending thick mixtures or when
large quantities of frozen foods with
liquids are used.
9 Plug in. (SB270 series - the base will
10 Press the low ' ' button for up to 30
seconds, this is to start the mixing
process, then press the high ' '
button. Allow the ingredients to
blend until smooth.
Use the stirrer by moving it in an anti
11 Place a glass underneath the tap,
press the low ' ' button and pull
forward the dispensing tap lever.
Thinner drinks may dispense without
having to switch on the power unit.
Use the stirrer to assist when
dispensing thick smoothie drinks.
To help dispense the last amount of
a thick smoothie drink, add a few
tablespoons of liquid to increase the
When the glass is full, switch off and
release the lever. Unplug after use.
Switch off ' ', remove the goblet
and pour the drink. Unplug after
To make a thinner smoothie drink
add more liquid.
To make a thicker smoothie drink
add more frozen ingredients but do
not exceed the frozen limit marked
on the goblet.
Before fitting the lid, push the solid
ingredients into the liquid using the
Use the pulse 'P' button to operate
the power unit in a start stop action
to control the texture of your drink.
Take care as this automatically
selects the higher speed and may
cause the drink to be thrown up the
sides and onto the lid of the goblet.