Replacement Filter Assembly; To Store Your Accessories; Vac Assembly - RIDGID WD0620 Owner's Manual

Wet/dry vac
Hide thumbs Also See for WD0620:
Table of Contents

Advertisement

Available languages

Available languages

Replacement Filter Assembly

1. Carefully slide the filter over the filter
cage, lining up hole in filter with
threaded stud and sliding it over the
center ring covering the 3 slots until the
filter stops against the lid.
2. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from filter as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage.

To Store Your Accessories

1. Slide extension handles and accesso-
ries on to posts of the caster feet for
storage.
2. To remove handles and accessories,
lightly rotate and pull upward.

Vac Assembly

1. Line up vacuum port above drum label.
2. Place lid on top of drum with the han-
dles snug against the drum channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid from
coming off.
Vacuum Port
Drum
Channel
5
Filter Nut
Filter
Filter
Cage
Power Head
Pull
Out
Flexible
Locking
Tab
Push
Down

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd0935Wd0625Wd0945

Table of Contents