Download  Print this page

Begin The Installation - Maytag 30" EYE-LEVEL MICROWAVE RANGE 30" EYE-LEVEL RANGE Installation Instructions Manual

30" eye-level microwave range and 30" eye-level range
Hide thumbs
   

Advertisement

Begin the
installation
Remove racks and all other contents
from oven
before moving
appliance.
Be sure to remove all
packaging
material
(cardboard,
protective
film,
etc.) from range before use.
A. Remove shipping skid
SHIPPING iKID
\
.m..CARDBOARDPADS
UNDER APPLIANCE
,.
Remove the 4 cardboard pads from shipping box. Place
them on floor as shown to protect appliance's
finish.
Rest appliance
(on its back) on pads.
Remove the two 318" shipping bolts from wooden skid.
Discard the skid.
B. Extend leveling legs
ADJUSTABLE WRENCH
BOTTOM OF
LEVELING LEG
Once skid is removed, 4 leveling legs are exposed at
bottom of frame.
Loosen legs by applying an adjustable wrench to the
1%" base of the leveling legs. Back each of them out
about 4 complete turns.
Stand appliance
on its base.
Begin electrical
connection
Grounding Instructions
WARNING:
THIS APPLIANCE
MUST BE CONNECTED
TO A
GROUNDED,
METALLIC,
PERMANENT
WIRING
SYSTEM, OR AN EQUIPMENT
GROUNDING
CON-
DUCTOR
SHOULD
BE RUN WITH THE CIRCUIT
CONDUCTORS
AND CONNECTED
TO THE EQUIP-
MENT GROUNDING
TERMINAL
OR LEAD ON THE
APPLIANCE.
CAUTION:
Before connecting
flexible armored cable
for permanent wiring, disconnect
power at fuse box or
circuit breaker.
A. Remove terminal block cover
3/8" BRASS NUTS
3
TERMINAL
BLOCK ,
COVER
Terminal
block cover is located on back of the ap-
pliance near the bottom.
Remove retaining screws to expose electrical terminal
block.
USE ONLY the supplied 3/8" brass nuts when connec-
ting cord.
USE ONLY ring type terminals
to connect cord.

Advertisement

Table of Contents
loading

  Related Manuals for Maytag 30" EYE-LEVEL MICROWAVE RANGE 30" EYE-LEVEL RANGE