Using A Headset; Using Autoanswer - Cisco 7906G Instructions For Use

Using a handset, headset, and speaker

Hide thumbs Also See for 7906G:

Using a Headset

To use a headset, disconnect the handset and connect a headset to the Handset port. For information

about purchasing headsets, see

Using Wideband with your Headset

If you connect a headset to the handset port, be sure that the Wideband Handset setting is disabled.

Choose User Preferences > Audio Preferences > Wideband Handset.

If the Wideband Handset setting shows as dimmed, then this setting is not user controllable

Note

and you must contact your system administrator to change this setting.

When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings.

Your system administrator can configure AutoAnswer to use the speaker to answer calls. However,

you can only monitor the call using the speaker. To talk to the caller, you must pick up the handset.

Cisco Unified IP Phone 7906G and 7911G User Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP) 3

Headset Support, page

Using a Handset, Headset, and Speaker

Table of Contents

7911g