3-14 FUEL SYSTEM
Installation is the reverse of removal.
Fit the slit [A] and the projection [B], and insert the throttle
valve assembly [C] into the carburetor body.
Replace the O-ring with a new one.
Install the insulator [A] between intake pipe [B] and car-
buretor [C] so that the O-ring faces to the intake pipe.
Torque - Carburetor Holder Bolts: 5.2 N·m (0.53 kgf·m, 46
After installing the carburetor, perform the following.
Check fuel leakage from the carburetor.
Fuel spilled from the carburetor is hazardous.
Adjust the following:
Idle Speed (see Idle Speed Adjustment in the Periodic
Throttle Grip Free Play (see Throttle Cable Adjustment
in the Periodic Maintenance chapter)
Remove the carburetor (see Carburetor Removal).
Pull the whole of spring [A] to the cap [B] side, and hold it.
Free the cable lower end [C] from the throttle valve [D].
Remove the retainer place [A] and the jet needle [B] with
the clip [C].