3-10 FUEL SYSTEM
Throttle Grip and Cable
Choke Cable Installation
Installation is the reverse of removal.
Install the choke cable in accordance with the Cable, Wire
and Hose Routing section in the Appendix chapter.
After the installation, adjust the cable properly.
Operation with improperly adjusted, incorrectly
routed or damaged cables could result in an unsafe
riding condition. Follow the service manual to be
make sure to correct any of these conditions
Adjust the choke knob operation as the following proce-
Pull the choke knob [A] fully.
Turn the adjuster [B] to adjust the hardness of the knob
If the adjuster too tight, the knob operation becomes
If the adjuster too loose, the position of the knob cannot
Choke Cable Lubrication
Whenever the choke cable is removed or in accordance
with the Periodic Maintenance Chart, lubricate the these
cable (see Lubrication in the Periodic Maintenance chap-
Choke Cable Inspection
Refer to the Cable Inspection in the Periodic Maintenance