Download  Print this page

Nut, Bolt, And Fastener Tightness Inspection; Tightness Inspection - Kawasaki KLX110 Service Manual

Motorcycle.
Hide thumbs

Advertisement

Periodic Maintenance Procedures
With the cable disconnected at the both ends, the cable
should move freely [A] within the cable housing.
If cable movement is not free after lubricating, if the cable
is frayed [B], or if the cable housing is kinked [C], replace
the cable.

Nut, Bolt, and Fastener Tightness Inspection

Tightness Inspection

Check the tightness of the bolts and nuts listed here in
accordance with the Periodic Maintenance Chart. Also,
check to see that each cotter pin is in place and in good
condition.
For the engine fasteners, check the tightness of them
when the engine is cold (at room temperature).
If there are loose fasteners, retorque them to the specified
torque following the specified tightening sequence. Refer
to the Torque and Locking Agent section in this chapter
for torque specifications. For each fastener, first loosen it
by 1/2 turn, then tighten it.
If cotter pins are damaged, replace them with new ones.
Nut, Bolt and Fastener to be checked
Wheels:
Spoke Nipples
Front Axle Nut
Front Axle Nut Cotter Pin
Rear Axle Nut
Rear Axle Nut Cotter Pin
Final Drive:
Chain Adjuster Locknuts
Rear Sprocket Nuts
NOTE
PERIODIC MAINTENANCE 2-39

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

This manual is also suitable for:

Klx110l

Comments to this Manuals

Symbols: 0
Latest comments: