2-38 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Check that the battery terminals are not corroded.
If necessary, remove the battery (see Battery Removal
in the Electrical System chapter) and clean the terminals
and cable ends using a solution of baking soda and water.
•
After attaching both cables, coat the terminals and cable
ends with grease to prevent corrosion.
•
Install the battery (see Battery Installation in the Electrical
System chapter).
Cable Inspection
General Lubrication
•
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
•
Lubricate the points listed below with indicated lubricant.
○
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
cation.
Points: Lubricate with Grease.
Clutch Inner Cable Upper and Lower Ends [A] (KLX110D)
Choke Inner Cable Upper End
Throttle Inner Cable Upper End
Cables: Lubricate with Rust Inhibitor.
Throttle Cables
Clutch Cable (KLX110D)
Choke Cable
NOTE
Comments to this Manuals
Latest comments: