15-38 ELECTRICAL SYSTEM
Electrical Starter System
Hold the carbon brush leads [A], using the suitable tool
[B] as shown.
Pull out the carbon brush spring [A].
Remove the brush holder screws [B] with lockwashers
and flat washers.
Remove the (–) carbon brush [C].
Remove the terminal cover plate screws [A] and terminal
cover plate [B].
Push the terminal [C] into the end cover.
Remove the terminal with (+) carbon brush.
Remove the brush holder plate [A] and insulator plates
Using a suitable tool (or oil seal remover), remove the oil
seal [C] from the end cover.
Using a suitable tool [A] (or bearing puller), remove the
bearing [B] from the armature shaft.