Download  Print this page

Hub Bearings; Hub Bearing Removal; Hub Bearing Installation; Bearing Inspection - Kawasaki KLX110 Service Manual

Motorcycle.
Hide thumbs

Advertisement

Table of Contents

Hub Bearings

Hub Bearing Removal

Remove the wheel (see Front/Rear Wheel Removal).
To remove the grease seals, pry out the grease seal using
a screwdriver.
Using the bearing remover shaft and bearing remover
head, remove the hub bearings [A].
Special Tools - Bearing Remover Shaft, 9: 57001-1265 [B]
Bearing Remover Head,
-1266 [C]

Hub Bearing Installation

Before installing the hub bearings, blow any dirt or foreign
particles out the hub with compressed air to prevent con-
tamination of the bearings.
Replace the bearings with new ones.
Install the bearings [A] using the bearing driver set [B] so
that the marked or shield sides face out.
Press in the bearings until they bottom out.
Special Tool - Bearing Driver Set: 57001-1129
For correct tire alignment, the right bearing must be in-
stalled first rather than left bearing in both front and rear
hubs.
Replace the grease seal [A] with new ones.
Apply high-temperature grease to the grease seal lips.
Press in the grease seal so that the seal surface is flush
[B] with the end of the hole using the bearing driver set
[C].
Special Tool - Bearing Driver Set: 57001-1129

Bearing Inspection

Since the hub bearings are made to extremely close tol-
erances, the clearance cannot normally be measured.
Do not remove any bearings for inspection. If any
bearings are removed, they will need to be replaced
with new ones.
Turn each bearing in the hub back and forth [A] while
checking for plays, roughness, or binding. If bearing play,
roughness, or binding is found, replace the bearing.
Examine the bearing seal [B] for damage or leakage.
If the seal is damaged or is leaking, replace the bearing.
10 × 12: 57001
NOTE
NOTICE
WHEELS/TIRES 9-13

Advertisement

Table of Contents

   Also See for Kawasaki KLX110

This manual is also suitable for:

Klx110l

Comments to this Manuals

Symbols: 0
Latest comments: