Raise the front/rear wheel off the ground with the jack.
Special Tool - Jack: 57001-1238
Spin the wheel lightly, and check for roughness or binding.
If the roughness or binding is found, replace the hub bear-
Visually inspect the front and rear axles for damage.
If the axle is damaged or bent, replace it.
Spoke Tightness Inspection
Refer to the Spoke Tightness Inspection in the Periodic
Rim Runout Inspection
Refer to the Rim Runout Inspection in the Periodic Main-
Rim Installation Position
When installing the rim, set the rim following position.
The distance [A] from the left end [B] of the front hub [C]
to left end of the front rim [D] should be as follows.
View from Front [E]
Distance: 9.0 ±0.5 mm (0.35 ±0.020 in.)
The distance [A] from the right end [B] of the rear hub [C]
to right end of the rear rim [D] should be as follows.
View from Rear [E]
Distance: 4.0 ±0.5 mm (0.16 ±0.020 in.)
Check the rim runout (see Rim Runout Inspection in the
Periodic Maintenance chapter).