Replace the axle nut [B] with a new one.
Insert the axle [A] from right side, and tighten the axle nut.
Torque - Front Axle Nut: 44 N·m (4.5 kgf·m, 32 ft·lb)
Insert a new cotter pin [C] to the front axle, and bend it to
Install the front brake cable and adjust the brake lever
free play (see Brake Lever Free Play Adjustment in the
Periodic Maintenance chapter).
Remove the jack.
Rear Wheel Removal
Raise the rear wheel off the ground with the jack.
Special Tool - Jack: 57001-1238
Adjusting Nut [A]
Cotter Pin [B]
Rear Torque Link Nut [C], Washer and Bolt
Cotter Pin [D]
Rear Axle Nut [E]
To remove the brake rod end from the brake cam lever,
first turn the brake panel clockwise [A] as far as it will go,
then depress the brake pedal lightly, the brake rod [B] will
be separated from the brake cam lever joint [C].
Remove the rear axle [D].
Disengage the drive chain from the rear sprocket.
Hang the chain on the swingarm.
Rear Brake Panel [E]
Remove the collar [A] on the left side of the hub.