Install the crankcase bolts in the left and right crankcase
half and tighten them, starting with the nearest ones to
the crankshaft, then farther ones.
Longer Bolts [A]
Shorter Bolts [B]
L: Apply a non-permanent locking agent.
Torque - Crankcase Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Check to see that the crankshaft, and out put shaft all turn
If the crankshaft will not turn, it is probably not centered.
Tap the mount portion of the crankcase with a plastic ham-
mer [A] to reposition it. If it does not free up, split the
crankcase again and find the cause.
Spinning the output shaft, shift the transmission through
all the gears to make certain there is not binding and that
all the gears shift properly.
Clean the cylinder and oil filter cap of the mating surface
and wipe off the liquid gasket forced out.
Install the removed parts.