Fit the crankshaft into the right crankcase half using a
Transmission Shaft Assemblies [A]
Shift Forks [B]
Check that the shift drum is in neutral position.
Make sure that the mating surfaces of the crankcase
halves are completely free of oil or contamination.
Apply liquid gasket to the mating surface of the left
crankcase half as shown.
Sealant - Liquid Gasket, TB1215: 92104-1065
Do not apply liquid gasket to this area [A].
Check that two dowel pins [A], O-rings [B] and drive shaft
spacer [C] are in place.
Using a suitable tool [A] on the left crankcase to press
around the hole for the crankshaft, fit the crankcase
halves together with a press [B] on the tool.
Remove the crankshaft jig [C].