Installation is the reverse of removal; note the following.
Replace the gasket with a new one.
Torque - Exhaust Pipe Holder Nuts: 16 N·m (1.6 kgf·m, 12
Replace the muffler mounting nut [B] with a new one.
Tighten the muffler mounting bolt [A] and nut in the follow-
Install the muffler mounting bolt to the frame [C] and
tighten it to the specified torque.
Torque - Muffler Mounting Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the muffler [D] and tighten the nut to the specified
Torque - Muffler Mounting Nut: 30 N·m (3.1 kgf·m, 22 ft·lb)
Loosen the nut, and tighten the nut again to the specified
Thoroughly warm up the engine, wait until the engine
cools down, and then retighten the bolt and nuts.
Spark Arrester Cleaning
Refer to the Spark Arrester Cleaning in the Periodic Main-
ENGINE TOP END 4-41