Brother DCP-J152W User Manual page 47

Error Message
Cannot Detect Ink
Cannot Print
Replace Ink
Cover is Open
Data Remaining
High Temperature
Cause
If you are using non Brother Original
ink, the machine may not detect the
ink volume.
One or more of the ink cartridges
have reached the end of their life. The
machine will stop all print operations.
The scanner cover is not locked in the
closed position.
The ink cartridge cover is not locked
in the closed position.
Print data is left in the machine's
memory.
The room temperature is too high.
Troubleshooting
Action
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact Brother
customer service or your local
Brother dealer.
Replace the ink cartridges. (See
Replacing the ink cartridges
on page 32.)
Lift the scanner cover, and then close
it again.
Make sure the USB cable (if used)
have been guided correctly through
the cable channel and out the back of
the machine.
Firmly close the ink cartridge cover
until it locks into place.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
After lowering the room temperature,
allow the machine to cool down to
room temperature and then try again.
B
41