Cleaning Various Parts of Your Appliance
Before cleaning any part of the warmer drawer, be sure all controls are turned OFF and the warmer drawer is
COOL. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW
WILL REDUCE THE EXTENT AND DIFFICULTY OF MAJOR CLEANING LATER.
Drawer Front Panel
Body Parts and Drawer
Warmer Drawer Rack
How to Clean
You may use a glass cleaner on the outside glass of the drawer. DO NOT
immerse the drawer in water. DO NOT spray or allow water or the glass
cleaner to enter behind the drawer glass panel. DO NOT use oven cleaners,
cleaning powders or any harsh abrasive cleaning materials on the outside of the
To remove control knob, turn to the OFF position; grasp ﬁ rmly and pull straight
oﬀ the shaft. Clean with a cloth soaked in soapy water. Rinse with a clean
water and a dishcloth. To replace knob after cleaning, line up the ﬂ at sides of
both the knob and the shaft; then push the knob into place.
Note: Humidity controller knob cannot be removed.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean
water and a cloth. Do not use cleaners with high concentrations of chlorides or
chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that
are especially made for cleaning stainless steel. Always be sure to rinse the
cleaners from the surface as bluish stains may occur during heating that cannot
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clear water and ammonia. If necessary, cover diﬃ cult spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water
and a damp cloth, and then scrub with a soap-ﬁ lled scouring pad. Rinse and
wipe dry with a clean cloth. Remove all cleaners or the porcelain may become
damaged during future heating. DO NOT use spray oven cleaners.
The rack may be removed for cleaning. If removed, clean by using a mild,
abrasive cleaner following manufacturer's instructions. Rinse with clean water