Error Messages On The Screen - Fujitsu LIFEBOOK E751 Operating Manual

Hide thumbs Also See for LIFEBOOK E751:
Table of Contents

Advertisement

Troubleshooting and tips

Error messages on the screen

Error message:
Error messages onthescreen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/cause
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is flat.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory an error has
resulted at the address xxxx.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Keyboard controller error
Keyboard error
nn Stuck key
Operating system not found
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
86
Resolution
► Contact your sales outlet or our customer
service centre.
► Switch the notebook off.
► Switch the notebook on.
► Press the function key
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Check whether the additional memory
module has been inserted correctly.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
► Switch the notebook off with the ON/OFF
switch.
► Wait 3 - 5 seconds and switch on the
notebook again.
If you are using an external keyboard:
► Check the connection and reboot the
notebook.
► Make sure that no key is pressed.
► Check in the BIOS Setup whether your hard
disk has been set correctly.
► Make sure that the operating system is
installed on the corresponding drive.
► Press the
F1
function key to start the
operating system.
► Press the function key
BIOS Setup.
F2
to access the
F2
to access the
Fujitsu Technology Solutions

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents